全國(guó)熱線服務(wù):
新聞資訊 Top label
- Revolutionizing High-Rise Building Care: The Essential Guide to Building Maintenance Units
- Advanced Locking Plate Technology: Revolutionizing Orthopedic Fracture Fixation
- Digital Pressure Sensors: Transforming Industrial Measurement and Process Control
- Digital Pressure Sensors: Transforming Industrial Measurement and Process Control
- Elevator Fall Arrest Anti-Fall Systems | Reliable Climber Safety Protection Solutions
- Steel Wire Rope Selection And Maintenance For Suspended Platforms
Understand the constant pressure process of honing tubes
1. In the shedding cutting stage, this kind of constant pressure honing starts because the hole wall is rough, the contact area between the whetstone and the hole wall is very small, the contact pressure is large, and the protruding part of the hole wall is quickly worn away. Due to the high contact pressure on the surface of the whetstone and the wear of the whetstone binder by chips, the bonding strength between the abrasive grains and the binder decreases. Therefore, some abrasive grains fall off on their own under the action of cutting pressure, and new abrasive grains are exposed on the whetstone surface, which is self-sharpening of the whetstone.
2. In the crushing and cutting stage, as honing proceeds, the surface of the hole becomes brighter and smoother, the contact area with the whetstone becomes larger and larger, the contact pressure per unit area decreases, and the cutting efficiency decreases. At the same time, the chips cut are small and fine, and the wear of these chips on the binder is also very small. Therefore, the whetstone abrasive grains fall off very little. At this time, the grinding does not rely on new abrasive grains, but is cut by the abrasive grain tips. Therefore, the load on the tip of the abrasive grain is very large, and the abrasive grain is easy to break and collapse to form a new cutting edge.
Honing tube
3. In the clogging cutting stage, when honing continues, the contact area between the whetstone and the hole surface becomes larger and larger. Very fine chips accumulate between the whetstone and the hole wall and are difficult to clean, causing the whetstone to become clogged and become very smooth. Therefore, the cutting ability of whetstone is low, which is equivalent to polishing. If honing is continued and the whetstone is seriously clogged and adhesive blockage occurs, the whetstone loses its cutting ability and becomes severely heated, and the hole accuracy and surface roughness will be affected. At this point, honing should be completed as soon as possible.
Please indicate the source when reprinting:http://www.hkgz.cn/
Please indicate the source when reprinting:http://www.hkgz.cn/